Image 1 of 5
Image 2 of 5
Image 3 of 5
Image 4 of 5
Image 5 of 5
Materials
The rubber stamp area is made on laser-recommended rubber material with a thickness of 2.3mm in Gray.
The wooden block is made of maple and comes in two sizes.
Optional add-on: Black Ink Pad
Product Size
The stamp block is sized at 3” x 3”, but the design itself varies in height and size leaving about 1/4” clearance on all sides.
Customization
Personalize your stamp to include your name, initlals, etc. A form will pop up to give you a chance to personalize your stamp.
Stamping Instructions
The general rule for stamping is to evenly apply ink to your stamp - not to put your stamp into your ink. The ink should be applied in an even manner - not too thin, but also not caked on (this could result in bleeding or smearing). After applying your ink, or inking, press the stamp onto your material of choice, in the position that you'd like, and press down firmly without rocking the stamp back and forth. Firm, even pressure will usually result in a much better-stamped image than rocking, which can cause smears and uneven printing. Allow ink to dry before touching.
Cleaning + Care Instructions
This is a traditional wood rubber stamps. It's always a good idea to clean them before packing them away. Stamp off access ink on your stamp by pressing the stamp on scrap paper repeatedly until no more ink comes off the stamp.
